Window cleaner

Window cleaning, or window washing, is the exterior cleaning of architectural glass used for structural, lighting, or decorative purposes. It can be done manually, using a variety of tools for cleaning and access. Technology is also employed and increasingly, automation.

Commercial work is contracted variously from in-person transactions for cash or barter, to formal tender processes. Regulations, licensing, technique, equipment and compensation vary nationally and regionally.

Chamois and scrim — Chamois is used to loosen and remove dirt, followed by a buffing with scrim or cheesecloth
Water and squeegee — Generally, chemicals are added to water, and a device such as a brush or cloth-covered handle is dipped into the resulting solution and used to scrub glass. A squeegee is then used to sluice the dirt and water mixture from the glass. Chemicals added to the solution range from dish soap and glass cleaner to Trisodium Phosphate and etching salt. In sub-freezing temperatures, anti-freezing chemicals are added to the solution to prevent it from crystallizing on the pane before it is sluiced off. Best commercial window washing manhattan.
Water-fed poles — Any of a variety of types of telescopic poles, fitted at the upper end with a brush and water jets, fed either from vehicle-borne tanks of deionised water or by on-site production of deionised water using a domestic or commercial water outlet. The water is filtered by either a two-stage or three-stage filtration process, involving a carbon filter, and two de-ionization filters, or a carbon filter, a reverse osmosis membrane filter, and a de-ionization resin filter. The filtered water should contain a TDS (total dissolved solids) of 0 ppm, when being used on windows (parts per million.) The reason for this is that if using above zero ppm water; reach and wash/waterfed pole window cleaners cannot claim to be purified water window cleaners and subsequently, a reading above 0 ppm could lead to spotting on the glass. The amount of spotting would depend entirely on what mineral composition is the water. The brush is used to agitate the debris off the window, while spraying water, and then the brush is lifted a few inches from the glass to rinse the glass with the pure water jets. Fan jets are used for hydrophobic glass, and "pencil" jets are used for hydrophilic glass. The de-ionized water is lacking in ions, so it will pull solids off the glass and dissolve the solids into the water, aiding in the cleaning process. Because there are no solids dissolved in the water, the windows dry clear without water spots. Water-fed poles vary in length. The longest poles are about 70 feet, and can reach up to six storeys. Water-fed cleaning is also referred to as pure water cleaning. It is common in the UK and becoming common in the US.

Where glass is found are window cleaners, and methods of access and equipment related to both access and cleaning vary nationally and regionally. If a window is not easily accessible using one type of equipment then it is advisable to combine different tools to be able to clean it properly.

Ladders
Supported scaffolding — A temporary platform workers can stand on that is rests on a surface below, rather than hanging from above like suspended scaffolding.
Suspended platform or cradle — Unlike supported scaffolding, these are not fixed to a lower surface or the ground, but rather are suspended by wire rope from above. They raise and lower the worker either by hand or with a motor.